Simplex TrueAlarm 4008- 9121, Installation, Programming And Operating Instructions

Page: 76 / 86

Chapter 8. Operating
8-4
Manually Activating a NAC/Relay
Follow these steps to manually turn a NAC or Relay on or
off, or set it to automatic operation.
1. Press <MENU>.
2. Press <NEXT> until Control/View is shown.
3. Press <ENTER>. Use the <NEXT> or <PREV> key to
select NAC or Relay.
4. Press <ENTER>. Use the <NEXT> or <PREV> key to
scroll through the list of points for NAC or Relay.
5. Press <ENTER> when the point you want to turn on or
off is displayed.
6. Press <NEXT> until a prompt similar to the following is
shown.
ENTER = Control AUX
TROUBLE
STEADY
7. Press <ENTER>. The following prompt appears.
ENTER = Accept
FN: ON
8. Use <NEXT> to select one of the following:
• ON. Use this option to turn the relay or NAC on. To
return the NAC/Relay to automatic operation, first
set it to OFF, and then reselect the point and set it to
AUTO.
• OFF. Turns the relay or NAC off.
• AUTO. Use this option to return the NAC or Relay
to automatic operation.
Enabling or Disabling Points
Use the following steps to enable or disable points.
1. Press <MENU>.
2. Press <NEXT> until Control/View is shown.
3. Press <ENTER>. Use the <NEXT> or <PREV> key to
select IDC, NAC, or Relay.
4. Press <ENTER>. Use the <NEXT> or <PREV> key to
scroll through the list of points.
5. Press <DISABLE/ENABLE> when the point you want
to turn enable/disable is displayed. A prompt similar to
the following appears.
IDNet1
FN: [Enable]
6. Use NEXT to toggle between Enable and Disable. Press
<ENTER>. A prompt appears asking you to confirm the
operation. Press <ENTER>. Keep the following in mind
when enabling/disabling points.
• When a monitor point is disabled, any status
changes occurring on the point are ignored by the
panel. If a control point is disabled, any automatic
functions are inhibited. A disable trouble will exist
for each disabled point in the system.
• When a monitor point is enabled, a 30-second
countdown will start to prevent an operator from
accidentally enabling a point that will alarm the
system. The point may be enabled immediately by
pressing <ENTER>, or the enable can be aborted
by pressing <EXIT>.
Control Functions
User control functions, such as Drill, City Disconnect, Con-
trol Point Bypass, and Elevator Recall Bypass are available
by pressing the <FUNCTION> key.
The table below shows the operations available in the Func-
tion menu.
Output
(LED)
a. Press <ENTER> to view a descrip-
tion of the first system point in the
list. Press NEXT to scroll through the
list of points.
System
Point a. Press <ENTER> to view a descrip-
tion of the first system point in the
list. Press NEXT to scroll through the
list of points.
Table 8-2 Additional Point Information (Continued)
Table 8-3 Control Functions
Function Description
Drill Activates the drill operation (all notifica-
tion appliances)
Manual Evacu-
ation Activates manual evacuation (general
alarm)
City/DACT
Disconnect Disconnects the city circuit or DACT
(causes a trouble)
Technical Manuals Online! - http://www.tech-man.com
firealarmresources.com