Simplex TrueAlarm 4008- 9121, Installation, Programming And Operating Instructions

Page: 38 / 86

Chapter 3. Auto-Programming
3-4
NAC, Relay, and Signal Circuit Output Mode
Assignments
Table 3-3 lists the default output mode (steady, temporal,
etc.) assignments for the NAC, Relay, and Signal circuits.
The output mode is a programmable attribute and it can be
manually changed, as described in Chapter 5 of this manual.
Annunciator Defaults
Annunciator cards found during the Auto-Program process
are added into the default configuration.
• LCD Annunciators are configured to receive all events.
Refer to Chapter 6 for information on manually pro-
gramming which events are received by the LCD
Annunciator.
• LED Annunciators and 24-I/O modules are not pro-
grammed for default operation.
DACT Defaults
The defaults for the DACT are listed below. Refer to Chap-
ter 5for information on manually programming the DACT.
• Tone else pulse dialing
• AC Fail reporting delay is 6 hours
• Reporting format is CID
• Primary and Secondary Phone Number. There are no
values for the primary and secondary phone numbers or
account codes.
• The CID Group and CID Point Identifier default to the
IDNet device address.
• Default event codes are shown in Table 3-4.
*Any other trouble not specifically mentioned would have a code of 330.
For example, a trouble on an output device would report an event code of 330.
SIGNAL OTS General Alarm Signal (on-til-silence)
ISOL ISOL IDNet loop isolator
SIG1-2 OTS General Alarm Signal (on-til-silence)
SIG3-4 OTR General Alarm Signal (on-til-reset)
AUX1 OTR General Alarm Relay (on-til-reset)
AUX2 TRBL Trouble Relay (on-til-clear)
Table 3-3 Default NAC, Relay, Signal Circuit Output
Mode Assignments
Circuit Default Output Method
SIG1-2 (NAC) Temporal Code A three pulse coding pattern
consisting of three ½ second pulses, each sep-
arated by ½ second silence. Each group of
three pulses is separated by 1.5 seconds of
silence.
SIG3-4 (NAC Synchronized. Used with visual NACs. Pro-
grams all visuals to flash simultaneously.
AUX1 & AUX2 Steady on
RELAY Modules Steady on
SIGNAL Mod-
ules Steady on
Table 3-2 Default Function Type Assignments,
IDNet Devices, NACs, and Relays (Cont’d)
Device
Function
Type
Description
Table 3-4 Default CID Event Codes
Function Type Fire Supervisory Trouble
FIRE 110 - 330
WATER 113 - 330
HEAT 114 - 330
DUCT 116 - 330
PULL 115 - 330
SMOKE 111 - 330
SO - 200 330
WSO 110 200 330
SUPV - 200 330
UTIL - - 330
TROUBLE - - 330
VSMOKE 111 - 330
LATSUPV - 200 330
STYLEC 110 - 330
OTHER TRBL* - - 330
Technical Manuals Online! - http://www.tech-man.com
firealarmresources.com