41
The administrator has the capability of updating SafeLINC FPII system firmware. This section
covers this capability.
Note:
To minimize any chance of error, reboot the system before performing this
procedure. For Rev. B and later SafeLINC FPII cards, you may press SW1 on
the SafeLINC FPII to reboot the system.
Be sure to read this procedure carefully before you attempt to update the firmware in the
SafeLINC FPII. Failure to do so may render the SafeLINC FPII inoperable. To avoid any
mistakes, verify your entries carefully before pressing the Enter key.
IMPORTANT:
Only experienced administrators or your local Simplex product
representatives should use the Update SafeLINC FPII screen. Improper
use of the Update SafeLINC FPII screen may render the SafeLINC FPII
inoperable.
1.
Log in as the User 1 Administrator on the web site.
2.
When the menu returns, click the Updating Firmware link on the right side of the screen.
3.
Now click the Start FTP Server. You should obtain the screen shown in Figure 39.
Notes:
•
Once the FTP Server is started, only User 1 can log in – all others are denied access.
•
Throughout the procedure, observe the Diagnostic Port (if available) for status
information.
Note:
The SafeLINC FPII reboots after 10 minutes of inactivity once the FTP Server is
started. The system also reboots upon successful update of the SafeLINC FPII
firmware.
HINT:
If you accidentally start the FTP server, don’t do anything and the SafeLINC FPII
reboots after 10 minutes of FTP inactivity.
Figure 39. Start FTP Server Verification Screen
Continued on next page
Updating Firmware
Overview
Firmware Update
Procedure
Summary of Contents for SafeLINC 4020-0160
Page 2: ......
Page 55: ...49 MIS IT Configuration Worksheet...
Page 56: ...50 MIS IT Configuration Worksheet Continued...
Page 57: ......