16
The following sections describe how to add the SafeLINC FPII to the FACP via the DOS-based
Programmer or the Windows-based Programmer. You will select a method (DOS or Windows)
according to what FACP will have the SafeLINC FPII installed in it. For example, the
4100U/4100ES and 4010ES FACPs with installed SafeLINC FPII will require the Windows-based
Programmer.
These sections are not intended to teach you how to use each Programmer; rather, they will point
out the important information that’s necessary to build a job properly to support the SafeLINC
FPII.
This section shows you how to add the SafeLINC FPII to a compatible FACP using the DOS-
based Programmer.
The SafeLINC FPII is configured in the 4100 Programmer as an Interface card type (similar to an
RS232, MAPNET, etc.). Data entry for the card is also similar to the RS232 with certain
limitations.
Use Steps 1 through 16 below to add a SafeLINC FPII to the FACP.
1.
Use a PC with the DOS-based 4100 Programmer application installed or install the
application on your PC. If necessary, refer to Publication 574-102 (4100 Programming
Instructions, Version 8.01) or Publication 579-127 (4100 Fire Alarm Programming Unit
Supplement, Version 9) for installation instructions on the 4100 Programmer application.
2.
Start up the 4100 Programmer on your PC by selecting the Start button from Windows, and
then selecting Programs, Simplex, and 4100 Programmer.
3.
Load a specific job from the
Utilities
menu.
4.
After the job is successfully loaded, use the arrow keys to select the
Configuration
menu
and press Enter (see Figure 10). If creating a new job, see the aforementioned Publications
574-102 or 579-127 for more information if needed.
Figure 10. System Configuration Menu
Continued on next page
Adding the SafeLINC FPII to the FACP via the Programmer
Overview
Using the
DOS-Based
Programmer
Summary of Contents for SafeLINC 4020-0160
Page 2: ......
Page 55: ...49 MIS IT Configuration Worksheet...
Page 56: ...50 MIS IT Configuration Worksheet Continued...
Page 57: ......
