Silverline 578256 Original Instructions Manual Download

Page: 7 / 46

18V Impact Driver

578256

silverlinetools.com

Fitting a driver bit

WARNING: DO NOT

fit any attachment with a maximum speed lower than the no load speed of

the machine .
1 . Pull the Collar (1) of the ¼

Bit Holder (15) forward away from the drill, and insert the bit

2 . Release the Collar
3. Pull on the bit to check that it is securely fitted. If the bit is not secure, repeat the above procedure

Note:

Make sure screwdriver bits used are hardened and suitable for use with an impact drill.

Operation

Direction control

WARNING:

NEVER change the direction of rotation while the tool is running. This may cause

permanent damage to the tool .
• The direction of rotation can be set using the Forward/Reverse Switch (3)
• Slide the Switch to the required position (Fig. IV).

Note:

When the Forward/Reverse Switch is in the central position, the drill is locked and cannot

be switched ‘ON’. Use this setting as a safety feature to prevent the drill from being switched ‘ON’

accidentally .

Switching ‘ON’ & ‘OFF’

WARNING:

ALWAYS wear adequate personal protection equipment when setting up and

operating this machine .
1. To start the impact drill, squeeze the Trigger Switch (13)
2. The built-in LED Work Light (14) will illuminate when the Trigger Switch is squeezed

Note:

If the Trigger Switch cannot be pressed down, check that the Forward/Reverse Switch (5) is not

set to its middle position, which locks the device (see ‘Direction control’ section).
3 . The speed of the Impact Drill is controlled by the movement of the trigger: the further the Trigger

Switch is pressed down, the faster the Impact Drill will run

4. Release the Trigger Switch to stop the machine

WARNING:

If the power tool gets excessively hot in use, stop using the tool immediately and

allow to cool before continuing work. The cooling period can be reduced by operating the Impact

Drill at maximum speed with no load. Always make sure the Motor Vents (2) are not blocked and do

not allow dust to enter the body of the tool through the Motor Vents; dust, especially metallic dust,

may damage or destroy the tool .

Battery Level Indicator

• The Batteries supplied have a built in Battery Level Indicator (4)
• To check the current Battery level, press the Battery Level Indicator Switch (6). While the Switch is

pressed the Battery Level Indicator will illuminate indicating the following.

Red LED only: Low charge, recharge
Red and Yellow: Medium charge
Red, Yellow and Green: Full Charge

Accessories

• A full range of accessories, including various types of screwdriver bits, is available from your

Silverline stockist

• Spare parts can be obtained from

toolsparesonline.com

Maintenance

WARNING:

ALWAYS disconnect from the mains power supply before carrying out any

maintenance/cleaning of the Battery Charger (8) . Remove the Battery before carrying out any

maintenance/cleaning of the impact drill .

Note:

Both the impact drill and the Charger contain no user-serviceable parts . If the device does not

perform as outlined in this manual, return it to an authorised Silverline service centre for repair .

General inspection

• Regularly check that all the fixing screws are tight
• Inspect the supply cord of the tool, prior to each use, for damage or wear. Repairs should be

carried out by an authorised Silverline service centre . This advice also applies to extension cords

used with this tool

Cleaning

• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and

shorten the machine’s service life. Clean the body of your machine with a soft brush, or dry cloth.

If available, use clean, dry, compressed air to blow through the ventilation holes

• Clean the tool casing with a soft damp cloth using a mild detergent. Do not use alcohol, petrol

or strong cleaning agents

• Never use caustic agents to clean plastic parts

Lubrication

• Slightly lubricate all moving parts at regular intervals with a suitable spray lubricant

Contact