![background image](http://html1.mh-extra.com/html/silverline/305706/305706_manual_1273287010.webp)
GB
10
Problem
Possible cause
Solution
Red LED does not illuminate to
indicate the Battery (8) is
correctly charging
Battery not correctly connected to Charger
Clean battery socket of Battery Charger (11) and Battery contacts and fully slide
on to Charger
Battery Charger not powered
Recheck mains connection
Battery pack has low capacity
Battery not being fully charged
Recharge Battery
Battery pack has been charged over 100 times and capacity
has started to reduce
This is normal for battery packs . Contact your Silverline dealer to purchase a
replacement battery pack
Drill driver cannot be switched ON
(Trigger Switch (14) does not move)
The Forward/Reverse Switch (6) may be in the middle
(‘locked’) position (Fig . IV)
Slide the Forward/Reverse Switch to the forward or reverse positon, see ‘Direction
control’ section
Drill driver does not start when
Trigger Switch is depressed
Battery completely discharged
Recharge battery or replace with a fully charged battery
Defective Battery
Replace Battery
Tool defective
Contact your Silverline dealer or authorised service centre
Troubleshooting
305706_Manual.indd 10
20/12/2017 08:48