8
GB
Problem
Possible cause
Solution
Red and green LEDs do not illuminate to indicate the Battery
(11) is correctly charging
Battery not correctly connected to Battery Charger Unit (15)
Clean battery socket of charger and battery contacts and fully
slide on to charger so it clicks in a locked position
Charger not powered
Recheck mains connection
Battery pack has low capacity
Battery not being fully charged
Do not remove Battery until a full charge is indicated
Battery pack has been charged over 100 times and capacity
has started to reduce
This is normal for battery packs. Contact your Silverline dealer
to purchase a replacement battery pack
Drill cannot be switched on (Trigger Switch (8) does not move)
The Forward/Reverse Switch may be in the middle (“locked”)
position
Slide the Forward/Reverse Switch either to the left or right
Drill does not start when Trigger Switch is depressed
Battery completely discharged
Recharge battery or replace with a fully charged battery
Defective battery
Replace battery
Drill machine defective
Contact your Silverline dealer or authorised service centre
Screws do not reach deep enough into the workpiece
Not enough torque; torque clutch setting too low
Choose a higher torque setting
Low battery voltage
Recharge battery or replace with a fully charged battery
Screws are driven too deep into the workpiece surface
Too much torque; torque clutch setting too high
Choose a lower torque setting
Drilling performance poor with masonry
Hammer mode not selected
Enable hammer mode
Drill bit tip worn or damaged
Replace drill bit
Very dense material
Drilling speed will be slow in such material. A smaller pilot drill
can be drilled first to speed up the drilling process
Troubleshooting
243507_Z1MANPRO1.indd 8
21/12/2016 11:14
