REKORD AY
Operating manual - English
20
Copyright Silca 2019
8.7
Replacing main switch
ATTENTION: turn off the machine and disconnect the supply wire.
1) Access the bottom part (see ch. 8.6).
2) Detach the 4 connectors (Y1) paying
special attention to their position.
3) Use a screwdriver to lower the internal tabs
fixing the switch, then pull it out.
4) Fit the new main switch.
5) Reconnect the 4 connectors (Y1).
6) Replace the bottom grate and secure with
the screws (Y) (fig. 27).
7) Turn the machine back into place on the
work bench.
Fig. 28
8.8
Replacing motor/condenser
ATTENTION: turn off the machine and disconnect the supply wire.
Motor
1) Remove the two protective pads (Q).
2) Loosen the 3 screws (M1) and remove the top cover (M)
(fig., page 17).
3) Detach the 4 connectors (S2) from the motor on switch.
4) Loosen the 4 screws (S1) (fig. 22) on the motor fixing
plate and remove the belt.
5) Loosen completely only the 2 lower screws (S1) the
motor fixing plate and pull downwards.
Fig. 29
Condenser
-
Access the bottom part (see ch. 8.6)
-
Remove the motor (see ch. 8.8 - Replacing motor)
-
Loosen the nut (Z) (fig. 31) and remove together with
the washer.
-
Loosen the 4 screws (S4) on the motor box and re-
move.
-
Loosen the 2 condenser connection screws (X1).
-
Loosen the nut on the wire grommet (X) and remove
the condenser.
-
Fit the new condenser, taking the wire through the nut
(X) replace the motor box and secure with the 4
screws (X1).
-
Tighten the grommet nut (X), replace the motor box
and secure with the 4 screws (S4).
-
Replace the condenser (see points 9 to 13).
-
Loosen the 4 screws (S3) on the motor fixing plate.
-
Secure the new motor on the fixing plate with the
screw (S3).
-
Replace the motor.
Fig. 30
6) Place the machine in position on the work bench.
7) Install the belt and tighten the 4 screws (S1) (fig. 22) of the plate motor.
8) Connect the 4 connectors (S2) (fig. 29) to the motor on switch and fit the earth wire to its screw with
the nut (S5) (fig. 33).
9) Replace the condenser and secure with washer and nut.
10) Replace the bottom grate and secure with the screws (Y) (fig. 27).
11) Place the machine in position on the work bench.
12) Replace the top cover and secure with the 3 screws (M1).
13) Replace the protective pads (Q).
Y1
S2
S3
