REKORD AY
Operating manual - English
8
Copyright Silca 2019
3.1
Further Risks
ATTENTION: there are residual hazards in the cutting zone (A) where the
cutter is located. Carefully observe the warnings in the manual.
•
To fit or remove keys from the clamp STOP THE
MOVEMENT OF THE CUTTER by means of the switch (N). If
this is not done the carriage may cause a hazard by going
unexpectedly towards the moving cutter.
•
After setting up the cutting code take care NOT TO MOVE
your free hand towards the cutter zone (A).
Fig. 5
3.2
Technical Data
ELECTRICAL PROPERTIES:
230V - 50/60Hz 440W 2A
CUTTING TOOL:
HSS Super Rapid Steel
MOTOR:
One-speed single phase 230V - 50/60Hz; 1350/1620 rpm 0,18 Kw
MOVEMENTS: manual
CLAMP: rotating
DIMENSIONS:
width: 330mm - depth: 430mm - height: 270mm
SONOROUS PRESSURE:
Leq. = 83 dB
WEIGHT: 18
kg.
3.3
Electric circuit
The REKORD AY key-cutting machine is provided with a single phase one-speed motor;
-
1350 rpm, consumes approximately 0.18 Kw, absorption 2A (230V/50Hz)
-
1620 rpm, consumes approximately 0.18 Kw, absorption 2A (230V/60Hz)
The main parts of the electric circuit on the REKORD AY are listed below:
1) Main plug with fuses
2) Safety main switch
3) Illuminated switch
4) Motor: 230V a.c. 50/60Hz
5) Condenser
6) Feeder
7) 6 LED circuit board (lamp)
A
N
black
red
Feeder (lamp)
6 LED circuit board
brown
light blue
light blue
brown
yellow/green
1
2
3
6
4
7
5
(
)
(
)
(lamp)
