REKORD AY
Operating manual - English
10
Copyright Silca 2019
5
MACHINE INSTALLATION AND PREPARATION
The REKORD AY key-cutting machine can be installed by the purchaser and does not require any
special skills.
However, some checks and preparation for use need to be carried out by the operator.
5.1
Checking for damage
The REKORD AY key-cutting machine is solid and compact and will not normally damage if transport,
unpacking and installation have all been carried out according to the instructions in this manual.
However, it is always advisable to check that the machine has not suffered any damage.
5.2
Environmental conditions
To ensure that the best use is made of the REKORD AY key-cutting machine, certain parameters must
be borne in mind:
-
damp, badly ventilated sites should be avoided.
-
The ideal conditions for the machine are:
- temperature: da 0 a 40°C
- relative humidity: 60% circa
5.3
Removing the blocks
Remove the protective panel (1) between the carriage and the machine body and the blocks (2 and 3)
between carriage and chippings tray (fig. 7).
Fig. 7
5.4
Positioning
Place the key-cutting machine on a horizontal surface, solid enough to take the weight (18 Kg).
To facilitate operation and maintenance, install the machine with a space of at least 200 mm on all sides
(fig. 8).
Ensure that the machine stands perfectly balanced on the four feet. Vibration is avoided when the
machine is properly set on the horizontal plane.
ATTENTION: ensure that the machine voltage is the same as that of the mains, which must be properly
earthed and provided with a differential switch.
Fig. 8
2
1
3
200 mm
200 mm
200 mm
