SIGLENT SDM3055A, User Manual

Page: 157 / 236

SIGLENT Remote Manual
17 SDM3055/SDM3055A
2.2.2 CALCulate:LIMit:{LOWer|UPPer}[:DATA] {<value>|MIN|MAX|DEF}
CALCulate:LIMit:{LOWer|UPPer}[:DATA]? [{MIN|MAX|DEF}]
Sets an upper or lower limit.
Parameter Typical Return
-1.0E+15to-1.0E-15
，
Or 0.0(default)
To +1.0E-15
至
1.0E+15
+1.0000
See Example.

You can assign a lower limit, an upper limit or both. Do not set the lower limit above
the upper limit.If the limit set is higher than the upper limit, the limit value is set to the
same limitwill force the same value.

Limit crossing: If a measurement is less than the specified lower limit, bit 11 ("Lower
Limit Failed") is set in the Questionable Data Condition Register. A measurement
greater than the specified upper limit sets bit 12 ("Upper Limit Failed"). See STATus
Subsystem Introduction for further information.
 A CONFigure command resets both limits to 0.

This parameter is set to its default value after a Factory Reset (*RST) or Instrument
Preset (SYSTem:PRESet).