Table 6-15
NTP Settings
Settings
Comments
NTP Server IP-Address
Actual Network Time Protocol (NTP) server.
The NTP server is the PC in the network providing the time. Enter either the
IP address or the Internet address.
NTP activated
Activation of the NTP (NTP activated check box on ) offers the possibility to
synchronize the time of the SWT 3000 via NTP protocol.
Default: NTP activated check box off ( )
Timezone Offset [hh:mm]
The time zone is always the GMT. Select the local deviation (up to ±12 h).
Poll Interval [1-65000 sec]
The poll interval describes how often the time is read from the NTP server.
Send
Send the values to the PU4 module.
Reset
Reject the changes.
The NTP Server IP-Address must be set according to the customers network.
NTP Daylight Saving Time
Network Time Protocol (NTP) is a networking protocol to synchronize the clock between an NTP server and a
SWT 3000 device. No information of time zone or daylight saving time (summer time) is provided by NTP,
which has to be configured manually using the Web server or SNMP SET command.
The Universal Time Coordinated (UTC) received from the NTP server will be adjusted with the setting of local
time zone or daylight saving time.
[scdaylig-300414-01, 1, en_US]
Figure 6-33
SWT 3000 NTP Daylight Saving Time Setting using the Web Server
Settings
Comments
Summer Time Switchover This enables daylight saving time switchover, it is only relevant for NTP.
If it is enabled, you have to configure the summer time offset, the begin and the
end of summer time also.
Summer Time Offset to
GMT [hh:mm]
Daylight saving time offset to GMT (Greenwich Mean Time).
The possible range of value: -12:00 to 12:00
6.4.4
SNMP and Remote Access
6.4 Web Interface
302
Smart Communication, SWT 3000 Teleprotection, Equipment Manual
C53000-G6040-C605-1, Edition 03.2020
