Cycles
9.13 Reciprocating – CYCLE415
Cylindrical grinding
198
Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
A_SR
Roughing allowance
A_SL
Finishing allowance
A_FSL
Fine-finishing allowance
SRZ, SLZ, FSLZ (infeed amount for roughing, finishing and fine-finishing)
When grinding by reciprocating, the wheel is fed in at the reversal points, depending on the
machining type (roughing, finishing or fine-finishing). The infeed amount is programmed
using the parameters SRZ, SLZ and FSLZ.
ZU_ART (infeed)
When grinding by reciprocating, the wheel is fed in at the reversal points. The ZU_ART
parameter is used to define whether an infeed by the infeed amount is to be performed only
at the left, at both or at the right reversal point.
=8B$57
=8B$57
=8B$57
%98
%98
BVU1 and BVU2 (holding time at the reversal point)
The dwell time at reversal point 1 or 2 can be defined using the following value:
"0 = Wait for exact stop fine and then wait for stopping time to elapse
The unit for the dwell time is given in workpiece speed after infeed.
F_SR, F_SL, F_FSL (feedrate)
Different feedrates can be specified for the individual machining steps. They are
programmed in [mm/min].
F_SR
Feedrate for roughing
F_SL
Feedrate for finishing
F_FSL
Feed rate for fine finishing
N_FR (number of sparking-out strokes)
Once the finished dimension is reached when grinding by reciprocating, a number of
additional reciprocation strokes are performed without further infeed of the wheel. These
strokes are called 'sparking-out strokes'. The number of the sparking-out strokes is defined
in the N_FR parameter.