Automatic mode
6.4 Block search
Cylindrical grinding
86
Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
6.4
Block search
Operating sequence
Requirement:The desired program has already been selected and the control system is in
the RESET state.
The block search function provides advance of the program to the required block in the part
program. The search target is set by positioning the cursor bar directly on the required part
program block in the part program.
Figure 6-7
Block search
Block search to block start
Block search to block end
Block search without calculation
The interruption point is loaded.
%ORFN
VHDUFK
7R
FRQWRXU
7R
HQGSRLQW
:LWKRXW
FDOFXODW
,QWHUU
SRLQW