Siemens SINAMICS RAILCTRL, Function Manual

Page: 85 / 106

Reaction: NONE
Acknowledge: NONE
Cause: The motor encoder does not support the "Encoder mounting" function. The configuration of right-hand or left-hand encoder
mounting is not possible.
See also: p30454 (RAILCTRL encoder mounting)
Remedy: Set the parameter for setting the encoder mounting to zero (p30454).
Note:
RAILCTRL: Controller for Segmented Linear Drives
Reaction upon F: OFF2 (NONE)
Acknowl. upon F: IMMEDIATELY
F53175 RAILCTRL encoder coordinate value range exceeded
Drive object: All objects
Message class: Application/technological function faulted (17)
Message value: Fault cause: %1
Reaction: NONE
Acknowledge: IMMEDIATELY
Cause: Configuration error of the Technology Extension RAILCTRL. The value range of one or several encoder configuration
coordinates is exceeded.
In this state, RAILCTRL is not ready for operation, and can only be activated once the cause has been resolved.
Fault cause:
1 (= 01 hex):
The start of the measurement range exceeds the valid value range (p30460).
2 (= 02 hex):
The length of the measurement range exceeds the valid value range (p30462).
Remedy: In general:
Check the grid spacing/scaling (p0407) or the fine resolution (p0418) of the encoder.
For fault cause = 1:
Check the start of the measurement range (p30460).
For fault cause = 2:
Check the measurement range length (p30462).
Note:
RAILCTRL: Controller for Segmented Linear Drives
See also: p30460 (RAILCTRL start of measuring range), p30462 (RAILCTRL measuring range length)
F53176 RAILCTRL geometry coordinate value range exceeded
Drive object: All objects
Message class: Application/technological function faulted (17)
Message value: Fault cause: %1
Reaction: NONE
Acknowledge: IMMEDIATELY
Faults and alarms
RAILCTRL
Function Manual, 09/2019, A5E38120767B
83