Siemens SINAMICS PERFECT HARMONY GH180, Function Manual

Page: 174 / 538

Set active config file Use this pick list to set the displayed file to be the active configuration
file.
This function overrides what is set in the SOP. Any change in the SOP
is checked against the file set in this function. Once a change in the
SOP is detected, that file will then be the active file. The keypad menu
setting is now ignored. This ensures no unintentional toggling of the
configuration files.
To switch back to the keypad file set it by this menu. If no change in the
SOP occurs, the keypad set configuration file will remain in memory.
Setup SOP config flags Use this submenu for SOP flag configuration.
Create new config file
Use this function to save slave parameters to a file name you specify.
Use the drive keypad to enter the file name. To get to the alphanu‐
meric characters, use the left or right arrow keys to position the cur‐
sor. Use the up or down arrow keys to scroll to the desired letter or
number.
Set
SOPConfigFileX_O
Use this function to map the name of the flag in the SOP
file,
SOPConfigFileX_O
(X = 1 to 8) to a name of a slave configu‐
ration file.
Once the SOP is running, and this flag is set to ‘true’, the configuration
file will be switched into memory. This is a method of switching
among multiple motors using one drive.
Select the file names from a pick list or create new files as described.
Table 6-102 Slave Setup and Configuration Parameters
Parameter ID Units Default Min Max Description
Multiple config files 9185 Off Enable multiple configuration file opera‐
tion.
Show active config file 9195 Display the current active configuration file
on the flash disk.
Set active config file 9196 defaults.sfg Set the displayed file to be the active con‐
figuration file on the flash disk.
Setup SOP config flags 9186 Submenu Access menu for SOP flag configuration.
Create new config file 9197 Create a new configuration file using the
numeric keypad.
Set SOPConfigFile1_O 9187 defaults.sfg Set the name of configuration file 1 to be
used with corresponding SOP flag 1.
Set SOPConfigFile2_O 9188 defaults.sfg Set the name of configuration file 2 to be
used with corresponding SOP flag 2.
Set SOPConfigFile3_O 9189 defaults.sfg Set the name of configuration file 3 to be
used with corresponding SOP flag 3.
Set SOPConfigFile4_O 9190 defaults.sfg Set the name of configuration file 4 to be
used with corresponding SOP flag 4.
Set SOPConfigFile5_O 9191 defaults.sfg Set the name of configuration file 5 to be
used with corresponding SOP flag 5.
Set SOPConfigFile6_O 9192 defaults.sfg Set the name of configuration file 6 to be
used with corresponding SOP flag 6.
Parameter Assignment/Addressing
6.19 Options for Multiple Configuration Files
Control Manual
172
Operating Manual, A5E50491925A