Procedure
To connect the external safety loop, proceed as follows:
1. Switch off the converter.
2. Remove the jumper over the terminals, inserted in the factory, that you wish to use.
3. Connect the external safety circuit to these terminals.
6.13
Interconnecting optional connections
Depending on the range of options installed, further connections have to be interconnected.
Detailed information about interconnecting these options with the interfaces is provided in the
circuit manual.
6.14
Connecting the re-cooling unit to the drive
Connect the cable provided for the cooling unit to the corresponding interfaces on the drive and
the cooling unit. Further details are contained in the circuit diagram of the drive and the re-
cooling unit.
6.15
Fastening the cable ducts with cable ties
Fasten all cable ducts whose cover faces downward with cable ties. Wind the cable ties around
the entire cable duct. The cable ties must be located at the same positions as in the delivered
state.
Figure 6-8
Schematic diagram: Fastening the cable ties
Electrical connection
6.15 Fastening the cable ducts with cable ties
3rd Party LCI Control Upgrade
96
Operating Instructions, 02/2022, A5E31872818
