WARNING
Danger when a transport unit/cabinet tips over
If the forks are too short, this can cause the transport unit/cabinet to tip over resulting in death,
serious injury, or damage to the cabinet.
• The forks of the truck must protrude at the rear of the transport pallet. The floor panels of
the transport units will not support a load.
• Only use fork-lift trucks approved for this purpose to transport the units.
• Carefully ensure that nobody is in the danger zone
①
.
When the transport units are transported or moved with a fork-lift truck, the force is absorbed
through the transport pallet.
Observe the following points for safe transport:
• Transport the transport unit/cabinet with the greatest care.
• Choose the lowest transport height possible. The pallet may not touch the ground. Always
transport the cabinet in an upright position.
• Avoid driving over bumps.
4.4.5
Transport with a crane
WARNING
Danger due to incorrect transport
If the transport unit is not properly transported with a crane, the transport unit/cabinet could
fall or tip over This can result in death, serious injury or material damage.
• Carefully comply with the safety instructions relevant for transport.
• Carefully observe the information regarding the center of gravity on the transport unit.
WARNING
Danger due to unsuitable cross-arms
If inappropriate cross-arms are used, the transport unit or cabinet can tip over. This can result
in death, serious injury or material damage.
• Observe the specifications provided in DIN EN 13155 on cross-arms.
Observe the following points for safe transport:
• When using a crane to transport the equipment, keep to the permissible lifting capacity. Pay
attention to the center of gravity position.
• If the cabinet center of gravity is off-center, use suitable lifting equipment, e.g. a lifting beam.
• If the cabinet has eye hooks, use them. In such cases, do not use any lifting rods.
Preparations for use
4.4 Transportation
3rd Party LCI Control Upgrade
70
Operating Instructions, 02/2022, A5E31872818
