Advanced commissioning
7.6 Basic positioner and position control
Converter with control units CU250D-2
196
Operating Instructions, 04/2015, FW V4.7.3, A5E34261542B AB
Defining the digital signals for controlling referencing
Procedure
To define the digital signals for controlling, proceed as follows:
1.
This signal starts flying referencing.
2.
For flying referencing, this signal must be 1.
The other signals are of no significance for flying referencing.
You have now defined the digital signals for controlling.
Defining the analog signals for controlling referencing
Procedure
To define the analog signals for controlling, proceed as follows:
1.
Define the signal source for the velocity override.
See also section: Direct setpoint input (MDI) (Page 220).
2.
Change the source for the reference point coordinate, if necessary.
You have now defined the analog signals for controlling.
