Siemens SENTRON PAC5100, Device Manual, Page: 139 / 266

7 Operation at Use of a PC
7.3 Configuration of the Device
139 SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
E50417-H1040-C568-A1, Edition 03.2015
To change the Recorder parameters , proceed as follows:
✧ In the navigation window, select the Recording and Reporting menu and click Recorder parameters .
Figure 7-37 Configure Tab, Recorder Parameters Input/Output Window
✧
Select the desired parameters in the list boxes and option fields as described in Table 7-12.
✧ After the parameterization click Send .
The parameters are transmitted to the device but not enabled yet (passive set of parameters).
✧ If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters . If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters .
NOTE
The voltage is recorded in the following connection types:
• in the connection type 3P4W (3 phases/4 wires): phase-to-phase voltage or phase-to-ground voltage
• in the connection type 3P3W (3 phases/3 wires): only phase-to-phase voltage
NOTE
Siemens recommends selecting the PQDIF setting from the Recorded file type list box. When selecting All or
CSV , the internal memory will be full prematurely if the CSV file becomes very large compared to the PQDIF file.