Siemens MOBY ES030-K, Manual, Page: 66 / 100

6AW5451-6XX01-1K ES 030-K Manual
6 - 2
Subject to change without prior notice
RD: 08.2000
(4)J31069-D0136-U001-A0-7618
6.2 Software
The ES 030-K can be tested in the display mode or in the test
mode while operating.
6.2.1 Display Mode
Display Mode (control variable)
The display mode is used to test while in operation (similar to
status on the PG). In the display mode, the keys have a fixed
assignment. The parameterization by the user will be ignored.
Key Assignment
7
4
1
8
5
2
0
9
6
3
DUE
E
C
A
F
D
B
- +
E A M T Z
U SPR DL DR
U = Switch between display mode and user
operation for keyboard and display.
SPR = Jump from display mode into the
test mode, as well as within test mode
- from NOP1 to NOP1(with key
switch vertical)
- from command to command (with
key switch horizontal)
= Moving the cursor to the next input field
DL = Selecting data left
DR = Selecting data right
E,A,M,T,Z = Selecting inputs/outputs, flags, times,
counters
0 to F = Input keys
+ = Increasing the address, flags, ...
- = Decreasing the address, flags, ... in the
change mask
DUE = Acceptance of the input
Display Definition
Actual value mask:
IST: x nnn DB yy
vv mmmm mmmm hhH aA
Flags, input byte numbers, etc. are selected with the keys
0 to 9. The value in the actual value mask is always
updated.
SETPOINT VALUE mask (change mask):
SOLL: x nnn DB yy
hhH
Inputs to the SETPOINT VALUE mask will only be entered
after the DUE key has been pressed. The keys +/- can
be used to increase/decrease
nnn.
moves the cursor
to the next input field.
The display will be maintained until a different pattern is
entered.
x = E,A,M,T,Z,DL,DR
nnn = Byte number of the input, output, flag,
number of the data word, counters, the
time
yy = DB number (only relevant with DL, DR)
vv = RLO 0 or 1 (only displayed in the test
mode)
m.. = value as bit pattern
hh = value in hexadecimal representation
(H = hexadecimal)
a = value in alphanumeric representation
(A = alphanumeric)
Jump into the Display Mode
Press the key parameterized with HEXADECIMAL E0
See Chapter 3.4.1
Working in the Display Mode (control variable)
Selection of E (inputs), A (outputs), M (flags), T (times), Z
(counters), DL (data byte left), and DR (data byte right), by
pressing the appropriate key. By pressing the keys again,
the mask will be switched from ACTUAL VALUE to
SETPOINT VALUE mask.
Leaving the Display Mode
The display mode will be terminated by pressing the key
designated
“
U" ( see keyboard allocation). The user mask
or a system message on a breakpoint will appear in the
display.
Caution: Changes in the contents (change mask)
are to be done in hexadecimal.
Inputs will only be updated at the
beginning of a cycle. Outputs will only
be output at the end of a cycle;
operations during the cycle will only be
carried out on the image. The pressing
of a function key will be entered into flag
byte 25 only at the beginning of a cycle.
FY 9 will not be altered in the test mode.
All times will be stopped during a
program halt.