Chapter
3
Operating Instructions
TPS
14
Operating Instructions | SICK
8021799/2017-09-26
Subject to change without notice
Product description
3
Product description
This chapter provides information on the special properties of the TPS driver assistance
system. It describes the design and operating principle of the system.
Always read this chapter
before
you mount, install and commission the system.
3.1
Scope of delivery
TPS consists of an LMS151 2D LiDAR sensor and two LD-MRS 3D LiDAR sensors, an
interactive operator display, a control cabinet, mounting kits with shock mounts and
connecting cables, GPS receiver, as well as a tone buzzer. Light signals can be optionally
used.
Fig. 1: Scope of delivery for TPS
Thorough check for completeness
It is recommended that you carefully check for and report transport damage of any kind
as soon as possible after receiving the system.
Also verify that the delivery includes all components listed on the delivery note.
3.2
System components
3D LiDAR sensor LD-MRS HD Front and Rear
The 3D LiDAR sensor LD-MRS HD mounted on the front and rear of the truck constantly
monitors the area in front resp. behind the truck, in a radius of up to 200 m (max. value of
warning zone of front LiDAR sensor).
The object detection is done with laser beams that the LD-MRS emits in four stacked
planes. The device measures the distance and the direction (the angle to the LD-MRS) of
the object.
Note
Important note