Operating Instructions
Chapter
6
TPS
8021799/2017-09-26
Operating Instructions | SICK
45
Subject to change without notice
Commissioning
6.4.2
Front sensor set up
In order to detect different vehicle sizes from haul truck up to small service and utility
vehicles, the front 3D LiDAR sensor has to be adjusted to cover a large observation zone
dependent on the individual mounting position. The setup procedure assists the installing
personal accordingly.
Click on the
Front
icon.
In the front sensor setup, only position measurements of the sensor position are required.
Enter the appropriate values and complete setup.
Sensor Front: Mounting position
The system setup firstly requires the designation of the front scanner mounting position.
Click on the plus or minus icon to set the distances. The value displayed increases or
decreases by 5 cm with each click.
If you click and hold on the icon, the value automatically goes up or down in increments
of 5 (auto repeat).
Sensor Front: Adjustment
The system setup requires the adjustment of the front sensor.
Although it is not verified here, angular adjustment of the frontal sensor is critical to
achieve the desired range and accuracy of the warning zones. Please use care to manually
verify the mounting of the sensor.
Note