Chapter
6
Operating Instructions
TPS
54
Operating Instructions | SICK
8021799/2017-09-26
Subject to change without notice
Commissioning
6.5.3
Saving sensor setup settings
All setups for the warning zones have now a green check mark.
Click on the
done
icon. The settings are permanently saved in the system.
You will then be taken back to the overview page with the individual setup steps.
The setup step
Supervisor setup
now has a green check mark.
6.6
Reverse Gear and components connection check
Click on the
information
icon.
The status of the gear shift is read from the signal supplied to the control cabinet. The
status shows here either
Active
or
Not active
. Once power (24 V) is applied to the reverse
signal line, the shown state should be
Active
. If this is not the case, please refer to the
troubleshooting chapter for solutions.
Make sure that truck ignition is on so that there is actually a signal on the reverse gear
input line when testing.
The info page gives also an overview of the functional state of system components.
Additionally the TPS output (control lights and siren) can be manually activated to check
the functionality and proper wiring.
This function is helpful to verify the cabling after installation.
Note
