Chapter
7
Operating Instructions
TPS
60
Operating Instructions | SICK
8021799/2017-09-26
Subject to change without notice
Operation
7.2.1
Black spot warning
Black spots are hazardous areas on mine site like intersections, construction areas,
crushers and workshops.
TPS warns the operator when the vehicle is entering a black spot by a short double-beep
sequence to raise operator’s attention.
Inside a black spot the operator is allowed to mute all alarms (e.g. when the truck is in
workshop for maintenance) and no RDW warnings will be made.
For the correct function of black spots, GPS must be available.
Click the
black spot target
icon on the display.
When a black spot was set successfully the “target”-icon turns into an “exclamation-mark”
icon.
Click the
speaker
icon on the display.
This will enable/disable sound output for this black spot area.
Click on the “exclamation-mark” to remove the black spot.
7.3
Reverse Driving
When the truck is in reverse gear, there are two different views:
Standard reverse view:
Default view in reverse gear. Only the rear end of the truck is
shown, with a red/yellow/green grid behind the vehicle. Objects behind the truck are
shown as colored grid areas. This view is used as long as only reverse warnings are
present.
Note
