8014868/YEF7/2014-09-02 • © SICK AG • Subject to change without notice 35
Operating instructions Distance sensors Dx35
Commissioning
Performing fine teach (continued)
3. Perform one of the following steps:
• Every time you press the
set (+)
pushbutton, you move
the previously taught-in point by +10 mm.
• Every time you press the
set (–)
pushbutton, you move
the previously taught-in point by –10 mm.
4.
In order to leave fine teach mode, either press the
select
and
set
pushbuttons simultaneously for less than 1 second or wait 30 seconds
without pressing the pushbuttons.
8.4
Configuring the speed
NOTE
The configured speed affects the measuring range,
repeatability, switching frequency, and response time to
be achieved.
→
For "repeatability" diagram, see Page 57,
Chapter 13.10.
→
For output rate, response time, and switching
frequency, see Page 54, Chapter 13.3.
1. Press and hold the
select
pushbutton for longer than 5 seconds. The
Q1
near
LED lights up.
2. Press repeatedly the
select
pushbutton until the LED
slow… fast
flashes.
3. Press repeatedly the
set
pushbutton until the desired speed has been
set.
• LED
slow … fast
flashes cyclically 1 x: super-slow
• LED
slow … fast
flashes cyclically 2 x: slow
• LED
slow … fast
flashes cyclically 3 x: medium
• LED
slow … fast
flashes cyclically 4 x: fast
• LED
slow … fast
flashes cyclically 5 x: super-fast
• LED
slow … fast
lights up continuously: expert setting, adjustable
only via IO-Link
→
See Page 43, Chapter 9.3.3.
4.
In order to leave teach mode, either press and hold the
select
pushbutton simultaneously for less than 5 seconds or wait 5 minutes
without pressing the pushbuttons.
