8014868/YEF7/2014-09-02 • © SICK AG • Subject to change without notice 31
Operating instructions Distance sensors Dx35
Commissioning
Example: Window teach is to be performed for the Q1 switching output.
1. Position object at teach point
2
.
2. Press and hold the
select
pushbutton for longer than 5 seconds. The
Q1
near
LED lights up.
3. Press the
set
pushbutton.
If the teach was successful, the setting is applied immediately. The
Q1
and
Q2
LEDs flash twice simultaneously. If the teach was not success
-
ful, the
Q1
and
Q2
LEDs flash alternately.
4.
If necessary, perform fine teach.
→
See Page 34, Chapter 8.3.
5. Position object at teach point
1
.
6. Press the
select
pushbutton. The
Q1 far
LED lights up.
Press the
set
pushbutton.
If the teach was successful, the setting is applied immediately.
The
Q1
and
Q2
LEDs flash twice simultaneously. If the teach was not
successful, the
Q1
and
Q2
LEDs flash alternately.
7.
If necessary, perform fine teach.
→
See Page 34, Chapter 8.3.
8.
In order to leave teach mode, either press and hold the
select
pushbutton longer than 5 seconds or wait 5 minutes without pressing
the pushbuttons.
