SICE S 63 E, Instruction Manual

Page: 99 / 356

Operator's Manual
S 63 E - S 63 E C
99
Keep the keys pressed to rapidly increase or decrease the previously set
values.
After completing the wheel data update, press the button to exit and display the
unbalance values recalculated according to the new dimensions, or to perform a wheel spin.
- if two subsequent measurements are taken inside the rim on two balancing planes, the ma-
chine interprets the presence of a rim with balancing using a clip weight on the inner plane
and an adhesive weight on the external one (ALU 2P).
In this phase, the machine could automatically change the type of weight on the inner plane
from clip to adhesive (ALU 1P).
In any case, the operator can change this setting by pressing the or key. In
this case, the balancing programme switches from ALU 1P to ALU 2P and vice versa.
Wheel data entry for wheel balancers with an ultrasonic sensor
(if installed)
To enter the distance, diameter and width values automatically, proceed as follows:
- bring the automatic internal measuring arm into contact with the inner side of the rim (fig.16).
During this phase, the graphic shown in figure 16a will appear on the display.
Take great care to position the arm correctly so as to ensure accurate data reading.
- Keep the arm in contact with the rim until the machine has acquired the wheel's diameter
and distance values. During this phase, the graphic shown in figure 16b will appear on the
display.
- if only one measurement is taken, the machine interprets the presence of a rim with balanc-
ing using a clip weight (Dynamic Balancing Programme)
- when the internal measuring arm returns to its idle position, “b” (or "Lr") will appear auto-
matically on the left display and the type of wheel will be shown on the right display:
-
P (Passenger Tyre) for medium sized wheels ( wheels with a tyre shoulder that does not
protrude much from the rim );
- Lt (Light Truck Tyre) for large sized wheels (such as off-road, trucks or wheels with a tyre
shoulder that protrudes considerably from the rim).
- use the key to select the type of wheel you are using.
- If you press the button in the phase indicated above, the width can be entered
manually using the keypad.
- in this phase, it is possible to perform a new acquisition of the rim planes.
- lowering the guard confirms the selection that was made (manual width entry or wheel type
selection) and a spin is performed and the wheel width is automatically measured.