SICE S 63 E, Instruction Manual

Page: 114 / 356

114
S 63 E - S 63 E C
Operator's Manual
OPERATING PHASES
OP.5
- turn the wheel until it is in the position shown by the position indicators.
- use chalk to make a double mark on the outer side of the tyre at the
12 o’clock position
Note: in this phase, press the key to display: the first time the
key is pressed, the actual unbalance values of the wheel as currently
mounted on the wheel balancer; the second time the key is pressed,
the obtained unbalance value continuing with the last phase of the op-
timisation procedure with the improvement percentage; when the key
is pressed for the third time, the machine prepares for the last phase
of the OPT programme
- remove the wheel from the wheel balancer
- on the tyre changer, move the double mark made in correspondence
with the valve
- press the key to confirm and end the unbalance optimisation
procedure.
Notes:
- The unbalance optimisation procedure can be quit at any time by pressing the
key; the displays will show the premature exit message:
Press the key to exit or the key to stay in the programme.
- The following message could be displayed at the end of the first spin:
Out 2
In this case it is advisable to exit the programme by pressing the key the values
of the weights necessary for balancing the wheel are displayed. The programme execu-
tion is interrupted, thus not achieving the moderate improvement of the end results.