SICE S 63 E, Instruction Manual

Page: 113 / 356

Operator's Manual
S 63 E - S 63 E C
113
12. OPTIMISATION PROGRAMME “OPT”
This procedure minimises any vibration still present on the vehicle while running even
after accurate balancing, thus minimising the rim-tyre coupling run-out.
Based on our experiences, the programme can be recalled every time it is convenient to
minimise the running noise produced by the vibrations mentioned above.
The calculations performed by this programme are based on the unbalance values measured
during the last spin performed which must therefore refer to the wheel being serviced.
• Press the key.
• use the keys to search for OPt
• press the key to activate the optimisation procedure
Programme activation is indicated by the illumination of the LED on the display
panel.
OPERATING PHASES
OP.1 H.12
- bring the valve to the "12 o'clock" position and press to
confirm
OP.2 180
- make a mark on the tyre 180° from the valve
- remove the wheel from the wheel balancer
- go to the tyre changer and move the mark made in correspondence
with the valve
- press the key to confirm.
OP.3 H.12
- Remount the wheel on the wheel balancer;
- Move the valve to the 12 o'clock position;
- press the key to confirm
OP.4
- perform a spin