-12-
SE
TU
P
Model W1807 7
1
⁄
2
HP Heavy-Duty Industrial Tilting Spindle Shaper
This shaper has been carefully packaged for safe trans-
portation. If you notice the machine has been damaged
during shipping, please contact your authorized Shop Fox
dealer immediately.
Unpacking
Keep machine disconnected from
power until instructed otherwise.
SETUP
The following is a description of the main components
shipped with the Model W1807. Lay the components out
to inventory them.
Inventory (Figure 3)
Qty
A.
Shaper (not shown) .......................................1
B.
Fence Mount Assembly ...................................1
C.
Spindle Shaft Nut Wrench ................................1
D.
Spindle Nut Wrench 36mm ...............................1
E.
Open End Wrenches
11/13mm, 17/19mm ............................... 1 Each
F.
Fence Boards ...............................................2
G.
Safety Guard ...............................................1
H.
Fence Mount Adjustment Knobs .........................2
I.
Hex Wrenches
1.5, 2, 2.5, 3, 4, 5, 5.5, 6, 8, 10mm ........... 1 Each
J.
Hold-Down Fingers ........................................4
K.
Miter Gauge ................................................1
L.
Vertical Hold-Down Bars .................................2
M.
Vertical Hold-Down Brackets ............................2
N.
Horizontal Hold-Down Brackets .........................2
Hardware (not shown)
• Hex Bolts M10-1.5 x 30 (vertical hold-down bars) ...2
• Hex Bolts M10-1.5 x 35 (fence boards) ................2
• Hex Bolts M10-1.5 x 40
(vertical hold-down brackets) ...........................2
• Hex Bolts M10-1.5 x 60
(horizontal hold-down brackets) ........................2
• Flat Washers 10mm
(fence boards & horizontal hold-down brackets) ....4
• Lock Washers 10mm
(fence boards & horizontal hold-down brackets) ....4
Inventory
Figure 3.
Model W1807 inventory.
H
I
J
K
L
M
N
B
C
D
E
F
G
NOTICE
If you can't find an inventory item,
check the mounting location on the
machine or examine the packaging
materials carefully. Occasionally we
pre-install certain components for safer
shipping.
Summary of Contents for W1807
