Shindaiwa DG15BMK, Owner'S And Operator'S Manual

Page: 44 / 52

39
Plug (R1 " )
Bolt (M6)
4 bolts
Guard
CLOSE
OPEN
<Note>

Replace the packing with a new part each time you change the coolant.

Packing part no.: 6C090-58961 (Kubota part no.)

Operate the engine for a short period and check that there is no coolant leakage. Stop
the engine when completed.
 Refer to section “8-2. Checking Coolant” for coolant information.
(7) Drain Fluid from the Spill Containment
Drain Pre-operation
1) Set a large pans or bucket under the drain port of the spill containment to catch the fluid.
2) Remove the guard by loosening bolts.
3) Remove the plug (R 1") of the spill containment drain valve by turning the plug counter
clock wise.
4) Tighten the (R 1") plug with thread seal tape to 19.6N-m. (By adjustable wrench)
5) Reinstall the guard.
<Note>

It is possible that there is a fuel or oil leak if the drained fluid contains oily components. If
this occurs, check for leakage locations.

Although the fluids that can leak internally consist of oil, fuel, coolant and battery fluid,
the spill containment does not have a function that can separate rainwater that has
leaked into the equipment from these internally leaked fluids. Properly dispose of fluids
drained from the spill containment in a manner according to the applicable laws and
regulations.
(8) Spill Containment Cleaning/Inspection
Clean / Inspect Every 400 hours or 1 year
Caution: Injuries

Always be sure to use the top-mounted lifting lug when lifting up the generator,
and raise it slowly at a completely vertical angle.

Wear a helmet, safety shoes, gloves and similar protective gear when
performing lifting work. Do not stand or get under the equipment while it is
suspended.

For spill containment cleaning/inspection, set this equipment with it situated on
a stable level surface so that it is prevented from moving.