Shindaiwa DG15BMK, Owner'S And Operator'S Manual

Page: 47 / 52

42
Caution: Injuries to Eyes and Skin

Use protective gear, such as rubber gloves, when inspecting or replacing the
Battery acid, Diesel fuel and/or Engine oil. Be sure that fluid does not contact
eyes, or on skin or clothing.

Battery acid, Diesel fuel and/or Engine oil can be very harmful If contact to eyes,
skin or clothing. If contact occurs, flush immediately with large amount of water
and contact physician.
Caution: Explosion

Do not operate the equipment or recharge the battery when the battery fluid level
is below the lower level.

Do not generate any sparks near the battery and do not allow any fire or other
open flames near the equipment because the battery generates ignitable gas.
Caution: Burns

The engine, muffler and similar parts and around them are extremely hot during
operation and immediately after stopping the equipment. Never touch hot parts.

Never open the radiator cap during operation or immediately after stopping the
equipment. Hot coolant and steam will spurt out.

Always be sure to stop the engine and leave the engine to cool down before
performing any inspection/maintenance such as engine oil checking or fuel filter
checking. Opening the oil level gauge or oil filler during operation will result in hot
oil spurting out.
Refer to the table below to perform inspection when the equipment is operating poorly.
If you cannot resolve a problem after inspecting the equipment, request repair at the retail
outlet where the equipment was purchased.
Symptom Possible Causes Remedy
Starter motor does
not start. 1. Battery has a low charge.
2. Battery is deteriorated. 1. Recharge the battery.
2. Replace the battery.
Engine does not
start.
1. Fuel valve is " CLOSE " .
2. No fuel
3. Emergency stop SW is
“ON”.
4. Terminal covers are opened.
5. Water or foreign material is
mixed in with the fuel.
6. Blown fuse
1. Turn the fuel valve to " OPEN " .
2. Add fuel.
3. Release Emergency stop SW.
4. Close the Terminal covers.
5. Drain water from and clean the
fuel tank and fuel strainer.
6. Replace the fuse.
Engine starts but
quickly stops.
1. Insufficient oil
2. Overheating of water
temperature
3. Battery recharging fault
1. Add oil.
2. Comply with rated outputs/Add
coolant .
3. Repair.
Black or white
smoke is
continuously
exhausted from
the muffler.
1. Overloaded 1. Comply with the rated output.
Engine does not
stop.
1. Stop solenoid fault 1. Turn the fuel
valve
to
"
CLOSE
"
to stop the engine and repair.
No AC power
output
1. Breaker is " OFF " . 1. Turn the breaker to " ON " .
AC power output is
weak.
1. The current of devices using the
equipment exceed the rated
current.
1. Refer to
"
Usable Device
Capacities
"
.