Shindaiwa DG15BMK, Owner'S And Operator'S Manual

Page: 42 / 52

37
(2) Replacing the Oil Filter
1st time 50 hours
2nd time
and after
Every 200 hours
1) Drain the engine oil according to the
procedures of " (1) Engine Oil Replacement".
2) Remove the oil filter using a filter wrench.
3) Apply a thin layer of oil to the gasket of a new oil filter.
4) Screw in the oil filter by hand and securely tighten by hand (do
not use a filter wrench) after the gasket contacts the seal surface.
5) Add engine oil.
6) Shortly after starting the engine, always be sure to check that there is
no oil leakage from the seal surface.
<Note>

Request the authorized distributor where the generator was purchased to perform this
procedure if you do not have a filter wrench.

Oil filter part no.: 1J090-32431 (Kubota part no.)

After adding engine oil, operate the engine for a short period and check that there is no oil
leakage. Stop the engine when completed.
(3) Air Filter Element Cleaning/Replacement
Cleaning Every 100 hours
Replacement Once in 6 times cleaning or 1 year
1) Remove the air cleaner clips and cleaner cap.
2) Remove the element.
3) Clean or replace the element. Reverse the procedure
above for re-assembly.
<Note>

Replace the elements earlier if using in an excessively
dusty location.

Element part no.: 1G319-11211 (Kubota part no.)
 Make sure “↑TOP” marks is at the top when
assembling the air cleaner cap.

Do not add oil as this generator uses a dry
element.

Clear foreign material by pinching the vacuator
valve once a week in normal operating conditions
or daily if operating in a location that is excessively
dirty or dusty. Wipe away any dirt or moisture that
has adhered to the parts.

Never touch the elements for any reason except
cleaning.

Cleaning the air filter element
If dry dust is adhering: Blow compressed air from inside the element.
If carbon or oil is adhering : Replace with new parts.
Oil Filter
Gasket
Clip
Air Cleaner
Clip
Air Cleaner Cap
Clip
Air Filter Element
Vacuator Valve