Shindaiwa DG15BMK, Owner'S And Operator'S Manual

Page: 19 / 52

14
(1) Water Temperature Monitor Lamp
The water temperature monitor lamp ("WATER TEMP") illuminates and the engine is
automatically stopped if the coolant temperature becomes irregularly high during
operation.
If this occurs, inspect the water level of the sub tank and add coolant if the
water level is insufficient.
（
Refer to section "8-2
.
Checking Coolant " .
）
If the coolant in the sub tank is at the specified level, it is probable that overloading is the
cause. Use within the rated output.
(2) Battery Charge Monitor Lamp
The battery charge monitor lamp ("CHARGE") illuminates and the engine is automatically
stopped if battery charge fails during operation. If this occurs, it is probable that there is
fan belt damage or a wiring fault. Request repair at the retail outlet where the equipment
was purchased.
(3) Oil Pressure Monitor Lamp
The oil pressure monitor lamp ("OIL PRESS") illuminates and the engine is automatically
stopped if the engine oil pressure drops during operation. If this occurs, inspect the
engine oil level and fill with engine oil until it reaches the maximum level.
<Note>

The oil pressure monitor cannot detect oil deterioration. Change the engine oil
periodically.
（
Refer to section "10
.
(1) Engine Oil Replacement" .
）

The charge monitor cannot detect battery deterioration or insufficient battery fluid.
Inspect the battery fluid level periodically.
（
Refer to section "8-6
.
Checking the Battery" .
）

If the engine is automatically stopped and none of the monitor lamps ("WATER TEMP",
"CHARGE" and "OIL PRESS") illuminates, this may be due to a blown fuse. To check the
fuse, lower the control panel.

If a fuse has blown, it is probable that there is a fault in an electric part or the wiring.
Request repair at the retail outlet where the equipment was purchased.
(4) Spill Containment Monitor Lamp
The spill containment monitor lamp ( "SPILL CONTAINMENT" ) illuminates if the level of
fluid in the spill containment is approximately 70% full (approx. 36 L) in order to ensure
that fluid accumulated in the spill containment does not spill out of the equipment. If this
occurs, drain the accumulated fluid from the equipment.
（
Refer to section "10. (7) Drain
Fluid from the Spill Containment" .
）
<Note>

The engine is not stopped if the spill containment monitor lamp illuminates during
operation.

When the spill containment monitor lamp illuminates during operation, stop the engine,
check for fuel, oil and coolant leakage, and repair as necessary.

Do not use the equipment with fluid accumulated in the spill containment. Drain the spill
containment before using.
（
Refer to section "10. (7) Drain Fluid from the Spill
Containment" .
）