Shimadzu MOC-120H, Instruction Manual

Page: 71 / 76

59
16. Maintenance
16-1 Performing Maintenance
Turn the power off and disconnect the power cable. Allow the heater and other parts
cool down to ambient temperature before performing maintenance.
Removing and reinstalling parts and components
Remove the sample pan, then the sample pan handler, sample pan supporter, and wind shield in
this order.
See “6. Assembly and Installation of Main Unit” on p. 9 for instructions on how to install parts and
components.
(1) Wipe away any dust or residue of spilled samples.
(2) Maintenance of the main unit
Use a soft, dry cloth to wipe away any dirt or soil.
Avoid applying strong pressure when wiping even if you find dirt or soiling difficult to remove.
If you find it particularly difficult to remove dirt or soiling, wet a cloth in water or in water with a
small amount of neutral detergent, wring the cloth thoroughly, and wipe. Next, rinse the cloth in
water and wring it out to remove any detergent and wipe again and then allow to dry.
(3) Maintenance of parts and accessories
Remove the spoon, spatula, sample pan, and wind shield from the main unit and wash in water
with a soft sponge.
Reattach to the main unit and wait until they completely dry before using the unit again.
* When using detergents, be sure to follow the instructions for use provided with the detergent.
* Never use paint thinner, benzene, or any volatile cleaning agents or any abrasive cleansers or
polishes.
* Never use wire brushes or other hard cleaning tools.
SALES & TECHNICAL SUPPORT
QAQC LAB www.qclabequipment.com TEL (804) 318-3686