Shimadzu MOC-120H, Instruction Manual

Page: 22 / 76

10
9
Close the heater lid
Set the Protection Cover on the display.
Adhesive tapes are attached to the Protection Cover.
0
Connecting the power cord
Insert the female end of the power cord into the
power inlet located at the rear of the unit. Then,
attach the three-prong plug adapter to the power cord
plug and insert the plug into power socket.
~ ~
100V 220V
120V 240V
A
Connecting the printer (optional)
If you use the optional printer, connect the printer
with the provided printer interface cable. For
instructions on how to use the printer, see the
separately provided DPU-414 Printer User’s Manual.
* Some parts must be oriented in a fixed direction for
assembly. Note that placing parts in the wrong
direction may prevent heater from closing or in
erroneous readings being obtained, and that you
should accordingly take care that all parts are put into
place in their proper positions.
B
Checking the power settings
Check the power conversion switch located on the
rear of the main unit to make sure that it is set to the
proper voltage setting for your power source. If not,
turn the switch to the correct position.
* Note that an error will occur if this switch is not set to
a position matching the power source being used.
SALES & TECHNICAL SUPPORT
QAQC LAB www.qclabequipment.com TEL (804) 318-3686