Shimadzu MOC-120H, Instruction Manual

Page: 66 / 76

54
15-2 Setting Up and Transmitting Data
15-2-1 Connecting the RS-232C cable
With the power to the MOC-120H and the computer both turned off, connect the RS-232C cable.
Connect the RS-232C cable to the RS-232C port located at the rear of the MOC-120H and tighten
the screws at both sides of the connector. Follow the same procedure to connect the RS-232C
cable to the computer. If the MOC-120H has been moved, make sure that the MOC-120H is
readjusted the level. (See “6. Assembly and Installation of Main Unit” on p. 9 for instructions.)
15-2-2 MOC-120H settings
Turn on the power to the MOC-120H and set the measurement data output format to ‘PC’. (See
“9-2-2 Specifying the type and format of output” on p. 31 for instructions.)
15-2-3 Setting Up the Computer
(leave the balance unplugged)
1 Turn ON the power to the computer and start
Windows
®
*.
2 Click “Start”, choose “Settings”, and “Control
Panel”.
3 Select “Accessibility Options.”
4 Verify that there are no check marks for any items
on all five tabs including “General.”
5 Put a check mark at “Support Serialkey device” in
the “General” tab. This should be the only check
mark on all the tabs of Accessibility Options unless
“Administrative options” appears in the “General”
tab. Put check marks at both the items of “Admin-
istrative options” to maintain the settings even after
restarting Windows
®
.
6 Open “Settings”.
7 Select the serial port corresponding to the RS-
232C port of your personal computer. (Serial port:
any one of COM1 to 4. Usually, COM1)
SALES & TECHNICAL SUPPORT
QAQC LAB www.qclabequipment.com TEL (804) 318-3686