95
4. Parameter description
Parameter
4.37 Slip Compensation Coefficient (P.89)
P.89 “Slip compensation coefficient”
● We can make the speed of the motor, which runs with rated current, to be much closer to the setting
speed by setting this parameter properly.
● This function is valid in V/F curve. It means P.300 must be set to 0.
Parameter Factory setting Setting range
Remarks
89
0
0~10
0
slip compensation is forbidden
10
compensation value is 3% of the target frequency
4.38 Frequency Jump (P.91~P.96)
P.91~P.96 “Frequency jump”
● To avoid the system mechanical resonance frequency, 3 sets of jump frequencies are presented,
namely, the first by P.91 and P.92, the second by P.93 and P.94 and the last by P.95 and P.96.
Parameter
Factory setting
Setting range
Remarks
91
～
96
9999
0~400Hz, 9999(Note 3)
9999, invalid
P.91
P.92 P.93 P.94 P.95 P.96
Output
frequency
(Hz)
<Setting>
• For example: Suppose that P.91 = 45 and P.92 = 50
If the target frequency
≦
45Hz, the steady output frequency = the target frequency.
If 45Hz < target frequency
≦
50Hz, the steady output frequency = 45Hz.
If 50Hz < target frequency, the steady output frequency = the target frequency.
Note: 1. During acceleration/deceleration, the output frequency of the inverter will still pass through the jump
frequency.
2. If P.91=9999 or P.92=9999, the first set of frequency jump is invalid.
If P.93=9999 or P.94=9999, the second set of frequency jump is invalid.
If P.95=9999 or P.96=9999, the third set of frequency jump is invalid.
3. If P.187=1, P.91~P.96 are in the range of 0~1000Hz.
