R..7, F..7, K..7, S..7, Spiroplan
®
W Gear Units – Operating Instructions
5
2
Safety Notes
2
Safety Notes
Preliminary
remarks
The following safety notes are principally concerned with the use of gear units.
If using geared motors, please also refer to the safety notes for motors in the corre-
sponding operating instructions.
Please also take account of the supplementary safety notes in the individual
chapters of these operating instructions.
General
During and after operation, geared motors and gear units have live and moving parts
and their surfaces may be hot.
All work related to transport, putting into storage, setting up/mounting, connec-
tion, startup, maintenance and repair may only be carried out by qualified specia-
lists in accordance with
•
the corresponding detailed operating instructions booklet(s) and wiring diagrams
•
the warning and safety signs on the gear unit/geared motor
•
the specific regulations and requirements for the system and
•
national/regional regulations governing safety and the prevention of accidents
Severe injuries and damage to property may result from
•
incorrect use
•
incorrect installation or operation
•
removal of required protective covers or the housing when this is not permitted
Designated use
These geared motors/gear units are intended for industrial systems. They correspond
to the applicable standards and regulations.
The technical data and the information about permitted conditions are to be found on the
nameplate and in the documentation.
It is essential for all specified information to be observed!
Transportation /
Storage
Inspect the delivered goods for any shipping damage as soon as you receive the
delivery. Inform the shipping company immediately. It may be necessary to
preclude startup.
Tighten installed transportation lugs firmly. They are only designed for the weight of the
geared motor/gear unit; do not attach any additional loads.
The installed lifting eyebolts meet DIN 580. The loads and guidelines listed in the
standard have to be observed. If there are two transportation or lifting eyebolts
installed on the geared motor, you have to use both of them for transportation.
The direction of the tensile force is not to exceed an angle of 45°to meet the
guidelines set forth in DIN 580.
Use suitable, sufficiently rated handling equipment if necessary. Remove any transport
fixtures prior to startup.
Summary of Contents for F 27 Series
Page 2: ...SEW EURODRIVE...
