4
28
R..7, F..7, K..7, S..7, Spiroplan
®
W Gear Units – Operating Instructions
Mechanical Installation
4.11
Installation on the AD input shaft assembly
See section "Installation of input and output shafts" for installation of input elements.
Version with
motor mounting
platform AD../P
Installation of motor and adjustment of motor mounting platform
1. Adjust motor mounting platform to required mounting position by evenly tightening
the adjusting nuts. For the lowest possible adjustment position of helical gear units,
remove eyebolts/transport lugs if there are any; touch up any damage to protective
coating.
2. Align motor on motor mounting plate (shaft extensions must be aligned) and secure
it.
3. Mount drive elements onto input shaft extension and install motor shaft, align these
to each other; correct motor position where necessary.
4. Install traction mechanisms (V-belts, chains, ...) and tighten by evenly adjusting the
motor mounting plate. The motor mounting plate and columns must not be tightened
against each other.
5. Secure threaded columns with the nuts not used for adjustment purposes.
AD6/P and AD7/P
only:
Loosen nuts and stud bolts before readjustment so that the stud bolts can be moved
freely in the support axially. Tighten nuts after the final position has been accomplished.
Do not adjust the motor mounting platform by using the support.
03519BXX
1
Motor mounting platform
2
Setscrew (AD6/P / AD7/P only)
3
Support (AD6/P / AD7/P only)
4
Nut
5
Threaded column
Summary of Contents for F 27 Series
Page 2: ...SEW EURODRIVE...
