61 |
P a g e
R e v 5 - 1 9
Optical switch with light sources
Halogen Lamp
To remove a lamp:
1.
Use a 3/32 Allen key to loosen the set screw identified with the red arrows.
2.
After pulling the lamp out of the aluminum housing, it should look like Figure 63 Above.
3.
To disconnect the lamp from the
system, press the tab indicated by the
red arrow while pulling the two ends of
the quick-connect away from each
other in Figure 64 above.
4.
To install a new lamp, reverse the last
three steps,
being careful not to
tighten the set screw in the aluminum
housing so hard that it damages the
lamp
. The set screw should be snug
with very little torque.
Lamp extender connection