Selectronic SP PRO 2i Series, Instruction Manual

Page: 101 / 113

SP LINK | Alert Messages
Doc #OI0005 Rev26 2020
|
101
Alerts and attention
required messages
Meaning and diagnostic Action Configuration
settings>
Inverter - Low AC Alert
cleared
The AC output of the inverter is now
OK. Inverter will not shutdown.
Inverter - Low AC
Shutdown
The AC output of the inverter was low,
normally due to power overload and
Inverter has shutdown
Start turning off loads and if
problem persists with little or no
load on the system, call your
installer to check for overload
or short circuits on the AC load
circuits.
Inverter - Low AC
Shutdown cleared
The AC output of the inverter is now
OK. Inverter will start again.
Inverter - Low Battery
Voltage Alert
Battery voltage getting close to
Shutdown voltage and shutdown is
imminent.
Firstly, reduce all the loads on
the system to the minimum.
Check that all the charging
sources such as PV solar
and generator charging are
functioning correctly. If problem
persists, call installer to check
for faulty cells in the battery
bank or for poor battery
connections between cells
and between battery bank and
SP PRO
Inverter-DC
shutdown
(group) >
Inverter 0% load
and Inverter
100% Load
Inverter - Low Battery
Voltage Alert cleared
The battery voltage has risen above
the to Recovery Voltage
Inverter-DC
shutdown
(group)
Inverter - Low SoC
Alert
Battery SoC is getting close to
Shutdown voltage and shutdown is
imminent. The loads on the system
maybe exceeding the charging source
Firstly, reduce all the loads on
the system to the minimum and
start your generator. Check that
all the charging sources such as
PV solar and generator charging
are functioning correctly.. If there
is a problem with one of the
charging sources then contact
your installer. If all is OK then
you will need to use less power
or run the generator more often.
Inverter-DC
shutdown
(group) >
Shutdown SoC
Inverter - Low SoC
Alert Cleared
The battery SoC and voltage has risen
above the to Recovery level
Inverter-DC
shutdown
(group) >
Shutdown SoC
and Recovery
Voltage
Inverter - Shutdown
Input Active
When programmed within the
SP PRO, this input is active and
the inverter is shutdown and
is not
producing any AC output.
Determine the source of the
input and remidy the fault
within that source
Input / Outputs
> Shutdown
Input
Inverter - Shutdown
Input Active Cleared
The Shutdown input is no longer
inactive and the inverter will come
back on.
Inverter - SoC
Shutdown
Inverter has shut down from Low SoC Firstly, reduce all the loads on
the system to the minimum and
start your generator. Check that
all the charging sources such as
PV solar and generator charging
are functioning correctly. If there
is a problem with one of the
charging sources then contact
your installer. If all is OK then
you will need to use less power
or run the generator more often.
Inverter-DC
shutdown
(group) >
Inverter 0% load
and Inverter
100% Load