Sega Dinosaur King, Owner'S Manual

Page: 17 / 121

− − − −
24
23
22
21
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
− − − −
② Connect one end of the earth wire to the
AC U nit earth terminal, and the other
end to the indoor earth terminal. The AC
U nit earth terminal has a Bolt and Nut
combination. Take off the Nut, pass the
earth wire through the Bolt, and fasten
the nut. <For Taiwan >
* Note that the earth wire is incorporated
in the power cord for the Areas of AC
120V ( U SA) and AC 220 ~ 240V, and
therefore, this procedure is not necessary.
③ Firmly insert the power plug into the
socket outlet. I nsert the opposite side
of the power cord plug to the AC U nit's
connector (" I N L ET").
④ P erform wiring for the power cord and
earth wire. I nstall protective insulation
for the power cord and earth wire.
Connect the earth wire to
the earth terminal.
FIG. 6.2b *Earth Wire Connection
FIG. 6.2c Connecting the Power Cord and Earth Wire
WIRING COVER
① Remove the separation paper of the
double-sided tape on the POP B back
side, and attach to the POP A fi rmly.
② Remove the 3 truss screws (M4 × 12)
from the cabinet, replacing them with the
3 supplied truss screws (M4 × 14), and
fasten the POP as shown in the fi gure on
the right.
The POP support board for this machine
is packed in air-wrap and secured to the
front of the monitor cover.
TRUSS SCREW (3), chrome
M4 14
POP SUPPORT
BOARD
POP A
POP B
3
ASSEMBLING THE POP
FIG. 6.3a
FIG. 6.3b