Sega Dinosaur King, Owner'S Manual

Page: 20 / 121

− − − − − − − −
24
23
22
21
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
Do not perform any of the following actions to avoid damaging the machine.
● Removing the Management Chip or turning the power on/off when the red
Management Chip reader/writer "BUSY" lamp is flashing.
● Removing/inserting Management Chips while a game is in progress.
● Inserting Management Chips/Cards designed for other machines or game
versions.
● Loading more than the maximum number of cards (600). Doing so can result in
card jamming or faulty dispensing.
● Turn off the power prior to using the card dispenser.
● Do not load used cards as they may jam or cause damage to the equipment.
When the credits reach zero and the warning screen is displayed, install a new Management Chip.
A Management Chip that causes the “EMPTY LAMP” to light up cannot be used.
There are two reader/writer units. If the chip is recognized by either one of them, the game can be
operated.
The status of the chip can be verified in Test Mode.
7. MANAGEMENT CHIP AND DINOSAUR KING CARDS
WARNING
！
STOP
IMPORTANT
7−1 INSTALLING MANAGEMENT CHIP
① Turn off the power switch inside the
door.
② L oosen the screw locking the
Management Chip holder.
③ I nsert the Management Chip fi rmly into
the Management Chip reader/writer slot.
④ Turn on the power switch inside the
door.
⑤ I f the � EM P TY L AM P � lights up, there
may be a malfunction. Check that the
chip is correctly inserted.
MANAGEMENT CHIP HOLDER
The Management Chip is supplied with the card set for use with this machine.
Notes：
・ Be sure to turn the power off and on again when inserting/removing Management Chips, even if
the machine is in use.
・ The counter in the Management Chip is set for the number of cards in one carton, and each
dispensed card reduces the counter number by . One Management Chip allows game operation
for one carton of cards.
PHOTO 7.1