1 of 4
X3 AUGER
INSTALLATION
© 2014 CribMaster. All rights reserved.
Purpose
The following document outlines the procedures for replacing a coil with an Auger into the tray of an
X3 vending unit and loading inserts into the installed Auger.
The Auger is an alternative vending coil for the X3 vending machine and is designed to individually
vend small unpackaged items. The Auger consists of two components: the auger coil and a sleeve to
hold items in place.
Remove Coil and Load Auger into the X3 Unit
1. Unlock and open the X3 door.
2. Slide selected tray out from the unit as far as it will go.
Note:
The drawer will remain connected to the X3 unit and will sit, still attached to the X3 unit, at
an angle of approximately 45° from the machine
(See Figure 1)
. From this position remove the coil
and install the auger as described in the following steps..
Figure 1
Revision 1 June 5, 2014
Summary of Contents for X3 AUGER
Page 4: ...4 of 4...
