3. To remove the existing coil from the tray, face the front of the tray and grasp the coil from positions
near the front of the tray and near the motor
(see figure 2)
.
4. Pull firmly until the coil releases from the motor drive.
Note:
Do not yank or jerk on the coil. Do not bend the coil upward when pulling it out. Keep it
level with the tray.
5. Place the auger into the sleeve and slide into the selected tray position. Push the coil adapter tip
into the motor drive until you feel it snap into place. If needed, adjust the auger sleeve by pushing it
into the tray
(see Figures 3 and 4)
.
Figure 2
Figure 4
Figure 4
2 of 4
Summary of Contents for X3 AUGER
Page 4: ...4 of 4...
