SEFRAM SFX+NETWORK, Technical Notice

Page: 59 / 108

Technical Data Sheet FI 72.0239.0320E
Page 59 / 108
OFFLINE CYCLE - CELL
This menu step is used to configure the dust removal order of the cells in a cycle.
Principle: a cell in which dust removal is to be performed is associated to a cell cycle number. A dust
removal cycle starts with the cell cycle number 1 and ends with the cell cycle number = to the NB STEP
OFFLINE-CELL.
If the arrow is placed on OFF LINE CYCLE - CELL and if the button is pressed, the following display
appears:
Note: Protected by code! appears if protection is activated.
To perform an adjustment:
- In protection not active mode, place the selection rectangle over the parameter to be adjusted using the
buttons.
- Press the
button, the parameter will be appear in a box with a flashing digit. Adjust this using the
buttons.
- Press the button, the parameter will be stored and the selection rectangle will appear again.
Depending on the configuration of the filter, the display zone can only display part of the dust removal
configuration of the cells. In this case, move horizontally in the table using the
buttons.
To exit the OFFLINE CYCLE-CELL menu, place the selection rectangle on QUIT and press the
button.
Possible adjustment range