SEFRAM SFX+NETWORK, Technical Notice

Page: 57 / 108

Technical Data Sheet FI 72.0239.0320E
Page 57 / 108
OFFLINE-WAY CYCLE
This menu step is used to configure the dust removal order in a cell. It is the same for all cells in the filter.
Principle: a pulse order number is associated to a dust removal solenoid valve. Dust removal in a cell
starts on the pulse with order number 1 and ends on the pulse with order number = to the parameter NB
STEP OFFLINE-WAY.
If the arrow is placed on OFFLINE-WAY CYCLE and if the button is pressed, the following display
appears:
Note: Protected by code! appears if protection is activated.
To perform an adjustment:
- In protection not active mode, place the selection rectangle over the parameter to be adjusted using the
buttons.
- Press the
button, the parameter will be appear in a box with a flashing digit. Adjust this using the
buttons.
- Press the button, the parameter will be stored and the selection rectangle will appear again.
Depending on the configuration of the filter, the display zone can only display part of the dust removal
configuration in a cell. In this case, move horizontally in the table using the
buttons.
To exit the OFFLINE-WAY CYCLE table, place the selection rectangle on QUIT and press the button.
Possible adjustment range