SEFRAM SFX+NETWORK, Technical Notice

Page: 67 / 108

Technical Data Sheet FI 72.0239.0320E
Page 67 / 108
NB.FLT.DUST. EMISS.
This parameter is used in the case of a configuration with a dust emission control. It determines whether
or not the filter cleaning on the solenoid valves which have presented a dust emission fault should be
continued (see dust emission faults).
-
Place the arrow on NB.FLT.DUST.EMISS. and press the button and the following display appears:
Note: Protected by code! appears if protection is activated.
To adjust the value, use
buttons. To quit and valid, press button.
Operating during one or several SV dust emission faults:
All of the Solenoid Valves (SV) where a dust emission fault has been detected are not pilot unless the
number of dust emission faults detected has reached the above set value.
- If the value is set at 0: the function is inhibited, all the Solenoid Valves are pilot whether or not
they are in dust emission fault.
- If the number of dust emission faults [is] greater or equal to the set value: all the Solenoid
Valves are pilot whether or not they are in dust emission fault.
- If the number of dust emission faults [is] lower to the set value: SV in dust emission fault are
not pilot.